Installing the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D Slimline media device with the system power on in IBM i

Use this procedure to install a new media device with the system powered on.

1. If you have not done so already, sign on with Service Tools Authority.
2. On an IBM i command line, type strsst. Press Enter.
3. Type your service tools user ID and service tools password on the System Service Tools (SST) Sign On display. Press Enter.
4. Select Start a service tool from the SST menu and press Enter.
5. Select Hardware service manager from the Start a Service Tool menu and press Enter.
6. Select Device Concurrent Maintenance from the Hardware Service Manager display and press Enter. The following figure is an example of the display.
   Figure 1. Example display of device concurrent maintenance

   
7. If the physical location does not appear in the Device Concurrent Maintenance display, perform the following steps:
   1. Find the feature code (FC) and sequence number (SN or SEQ) on the label that appears on the front of the system unit as shown in the following figure.
   2. In the Specify either physical location or resource name field, type the physical location where you want to replace the media device. In the previous example, opt04 is the device resource name.
   Figure 2. Example of the label on the front of the system unit
8. Select option 2 (Install device) for the action to be performed.
9. Set the time delay of 1 minute by typing 01 in the Enter a time value between 00 and 19 field and press Enter. Watch the lights on the left side of the media devices. When you press Enter, after a 1-minute delay, the amber light comes on solid.
   Important: You have 15 seconds to insert the media device.
10. Remove the front cover:
    • For a rack-mounted system, see Removing the front cover from a rack-mounted model .
    • For a stand-alone system, see Removing the front cover from a stand-alone model .
11. For a rack-mounted system, place the system into the service position, as described in Placing a rack-mounted model into the service position.
12. While holding the retaining tab (A), push the device fully into the system as shown in the following figure.
    Figure 3. Installation of a Slimline media device

    
    The solid amber light turns off and the green lights turn on for both media slots when you have correctly installed the media device.
13. Return to the console and wait until the Concurrent Maintenance Results display is shown and then press Enter.
14. Press F12 (Previous) to return to the Hardware Service Manager display.
15. Exit System Service Tools.
16. On the command line, type wrkcfgsts *dev and press Enter.
17. On the Work with Configuration Status display, type 1 (Vary on) next to the media device that you replaced to make it available. Press Enter. The status becomes active.
18. Press F12 (Previous) to exit the Work with Configuration Status display.
19. Verify the installed part:
    • If you replaced the part because of a failure, verify the installed part as described in Verifying a repair.
    • If you installed the part for any other reason, verify the installed part as described in Verifying the installed part.
20. Replace the front cover:
    • For a rack-mounted system, see Installing the front cover on a rack-mounted model.
    • For a stand-alone system, see Installing the front cover on a stand-alone model.
21. Close the front rack door.