Removing a part by using the HMC

Learn how to remove a part by using the Hardware Management Console (HMC).

About this task

To remove a part in a system or an expansion unit by using the HMC, complete the following steps:

Procedure

  1. In the navigation area, click the Resources icon Resources icon, and then click All Systems.
  2. Click the system name for which you want to remove a part.
  3. In the navigation area, click Serviceability.
  4. In the Serviceability window, click Remove FRU.
  5. In the Add/Install/Remove Hardware - Remove FRU, Select FRU Type window, select the system or enclosure from which you are removing the part.
  6. Select the type of part that you are removing, and click Next.
  7. Select the location of the part that you are removing, and click Add.
  8. After the part is listed in the Pending Actions section, click Launch Procedure and follow the instructions to remove the part.
    Note: The HMC might display the IBM® Knowledge Center instructions for removing the part. If so, follow those instructions to remove the part.