Preparing the system for operation

Procedure

  1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
  2. Replace the service access cover. For instructions, see Installing the service access cover.
  3. Place the system into the operating position. For instructions, see Placing the system into the operating position.
    (L012)
    Pinch hazard
    CAUTION:
    Pinch hazard. (L012)
  4. Install both of the power supplies into the system. For instructions, see Installing the power supplies.
  5. Reconnect the power cords to the system. For instructions, see Connecting the power cords.
  6. If applicable, close the rack door at the rear of the system.
  7. Start the system. For instructions, see Starting a system.
  8. Replace the front cover. For instructions, see Replacing the front cover.
  9. If applicable, close the rack front door.
  10. Verify the installed part. See Verifying a repair in the 8335-GCA or 8335-GTA.
Parent topic: Installing PCIe adapters in the system backplane in the 8335-GCA or 8335-GTA system
Previous topic: Installing a PCIe adapter in the system backplane of a 8335-GCA or 8335-GTA system


Last updated: Mon, August 07, 2017