Using AIX or Linux commands to work with the temporary and permanent side of the service processor

Learn how to use AIX® or Linux commands to determine which side of the service processor you are booting from.

1. Issue the following command at the AIX or Linux command prompt:

   lsmcode

   Note: If the lsmcode command does not work at the Linux command prompt, you need to obtain the service and productivity tools for Linux.
2. Record the information that is displayed. You will need this information later in this procedure if you need to change the boot side. The information that is displayed is similar to:
   • AIX: The system is currently booted from the xx image (either temporary or permanent).
   • Linux: The (b) booted side shows whether the firmware matches the temporary or permanent side code.

     system:EM310_006 (t)  EM310_005 (p)  EM310_006 (b)

3. If necessary, you can change the boot side.