POWER7 information

Rebuilding data on a replacement disk drive by using Linux

Use this procedure to rebuild data on a replacement disk drive.

To rebuild data on the replacement disk drive, complete the steps listed here.

For an unprotected disk drive

If the disk drive you are replacing is in a RAID Level 0 disk array or in a failed RAID Level 5 or RAID Level 10 disk array, complete the following steps:

Re-create the disk array.
Re-create the file systems on the disk array.
Copy the data back to the restored disk array from your backup media.

For information on these tasks, see the PCI-X SCSI RAID Controller Reference Guide for Linux, SA23-1327.

Send feedback Rate this page

Last updated: Fri, March 20, 2015