Removing an application monitor

Edit online

You can permanently remove an application monitor.

About this task

To permanently remove an application monitor:

Procedure

  1. From the command line, enter smit sysmirror
  2. In SMIT, selectCluster Applications and Resources > Resources > Configure User Applications (Scripts and Monitors) > Configure Application Monitoring and press Enter.
  3. Depending on which type of monitor you are altering, select either:

    Configure Process Application Monitor > Remove a Process Application Monitor

    or

    Configure Custom Application Monitor > Remove a Custom Application Monitor.

  4. Select the monitor to remove.
  5. Press Enter. The selected monitor is deleted.

Results

If the monitor is currently running, it is not stopped until the next dynamic reconfiguration or synchronization occurs.

Note: If you remove an application monitor, PowerHA® SystemMirror® removes it from the definition for all application controllers that were using the monitor, and sends a message about the servers that will no longer use the monitor.

If you remove an application controller, PowerHA SystemMirror removes it from the definition of all application monitors that were configured to monitor the application. PowerHA SystemMirror also sends a message about which monitor will no longer be used for the application. If you remove the last application controller in use for any particular monitor; that is, if the monitor will no longer be used for any application, verification issues a warning that the monitor will no longer be used.