startservice

Use the startservice command to enter a service state.

Syntax


>>- satask -- startservice -- --+----------+-- --+--------------+-><
                                '- -force -'     '- panel_name -'

Parameters

satask: System Administrator task; service commands that are only used in specific circumstances.
-force: (Optional) Overrides checking of clustered system (system) membership.
Important: Using the force parameter might result in a loss of access. Use it only under the direction of your product support information .
panel_name: (Optional) Identifies the node being serviced.

Description

This command enters a service state. For example, you might use a service state to remove a node from the candidate list, or to prevent it from automatically being added to a system again. The -force flag is required if the action could interrupt I/O (last node in cluster or IO group). This command holds the node in service state until it is cleared using the satask stopservice command, or until the I/O process is restarted.

An invocation example

satask startservice

The resulting output:

No feedback