The customer-extended panel functions include partition
dumps, service processor IP address and port location.
Function 21: Service tool initiation For System i® models,
this function makes dedicated service tools (DST) available on the system
console display.For System p® servers,
it is not applicable.
Function 22: Partition dump
This function initiates a dump of the operating system
data in a logical partition.
Functions 25 - 26: Service switches 1 and 2
These functions are used to set the service function range (50
to 99). These functions are available only in the manual operating mode.
Function 41: Nondisruptive platform system dump
This function initiates a nondisruptive platform system
dump. This function is available only in the manual operating mode
and when activated by the service processor.
Function 42: Platform system dump
This function initiates a platform system dump. This function
is available only in the manual operating mode and when activated
by the service processor.
Function 43: Service processor dump
This function initiates a service processor dump. This
function is available only in the manual operating mode.
Functions 56 - 62: Reserved
Functions 56 - 62 are reserved on systems running system
firmware level Ax710. Functions 57 - 62 are reserved
on systems running system firmware level Ax720
or later.
Function 56: Select IPL diagnostic level
On systems that are running on system firmware level Ax720,
or later, you can select the IPL diagnostic level for the next system
boot by using this function.
Function 63: Display system status SRCs
When you select function 63 and press Enter, you can display
up to the last 25 system status SRCs. This function is available only
in the manual operating mode.
Function 64: Display diagnostic status SRCs
When you select function 64 and press Enter, you can display up
to the last 25 diagnostic status SRCs. This function is available only in
the manual operating mode.
Subscribe to this information