Use this procedure to install the cover to access components
or perform service.
To install the front cover and front door, complete the following
steps.
- Align the cover (A) until the two
cover tabs are seated into the slots on the base plate (B),
as shown in the following figure.
- Rotate the cover up and towards the system until the release
latch is seated into its respective slot. The cover has
an indentation where you can hold onto it more easily.
Figure 1. Installing
the front cover
- Hold the front door at an approximate 120 degree angle
to the system as shown in the following figure. Engage the latches.
Figure 2. Installing the front door
Subscribe to this information
