GIM21902W enttype ENTRY entname IN THE zonename ZONE WAS NOT PROCESSED BECAUSE THE PEMAX VALUE IN THE CURRENT OPTIONS ENTRY WAS EXCEEDED.

Explanation

enttype
entry type
entname
entry name
zonename
name of the zone being processed
SMP/E could not create, update, list, or process the indicated entry, because the SYSMOD entry needs a PEMAX value greater than the value in the current OPTIONS entry.
Note:
  1. This message may indicate that the entry has incorrect data. This may have been caused by an internal SMP/E error.
  2. During APPLY or ACCEPT processing, this message may be issued when SMP/E is building a candidate list for mass-mode processing. In this case, the entry name and entry type values in the message may refer to SYSMODs that are eventually eliminated during SYSMOD selection processing. The PEMAX value in the OPTIONS entry being used needs to be increased.

System action

Processing stops for the indicated entry.

Programmer response

Do one of the following, as appropriate:
  • Use UCLIN to increase the PEMAX value in the OPTIONS entry.
    Note: Do not decrease the PEMAX value after SMP/E processes SYSMODs with a larger PEMAX, because existing SYSMOD entries may be too large for SMP/E to process.
  • Make sure the OPTIONS entry containing the increased PEMAX value is the same as the OPTIONS entry named in the zone definition entry.
  • If the entry has incorrect data, either correct the data or restore the data set and rerun the job.