IEC615I   ABEND=code-reason OCCURRED IN THE ModName EXIT MODULE FOR DYNAMIC EXIT Dynex_ExitName

Explanation

A data management exit module received control and abnormally terminated. Dynamic exit services in the system for the dynamic exit name of Dynex_ExitName called exit routine moduleModName. The abend code and reason that occurred in this exit routine is displayed in code-reason.

System action

Data management functions continue, but the exit routine is unable to alter the function. Exit routine Dynex_ExitName is deactivated, as indicated by accompanying system message CSV430I and will not be invoked again until reactivated.

Operator response

Notify your system programmer.

Programmer response

Perform the following steps:
  1. Determine the cause of the failure by analyzing the system dump using IPCS.
  2. Correct the source code in the exit module.
  3. Recompile or assemble the exit module.
  4. Link a new version of the exit module into the program library containing the exit module.
  5. If the program library containing the exit load module, is managed by the Library Lookaside Facility (LLA), then use the MVS operator MODIFY LLA command, in conjunction with a CSVLLAxx PARMLIB member, to refresh the load module being managed by the Library Lookaside Facility.
  6. Reactivate the exit routine, issue SETPROG EXIT commands at an MVS system console.

Source

DFSMSdfp data management (DADSM)

Module

IGGDYXCS

Routing code

2,10

Descriptor code

4