IEC602I text
Explanation
[VTOC NOT CONVERTED ON dev,ser,cde]
[VTOC NOT CONVERTED ON dev,ser,0,
,(EXTENT=cchh,DSCB=cchhr-cchhr)]
[VTOC NOT CONVERTED ON
dev,ser,cde, ,(EXTENT = cchh,DSCB =
cchhr)]
When the system tried to allocate DASD space on volume ser on unit dev, the volume table of contents (VTOC) conversion routine entered, but failed to convert or repair the VTOC.
- dev
- The device number of the specified device.
- ser
- The volume serial number.
- cde
- The code.
- Cde 1C
- There were insufficient DSCBs available to rebuild the free space chain. The VTOC is full.
- Cde 1D
- An I/O error occurred.
- EXTENT=cchh
- Specifies the first track that appears to be multiply allocated.
- DSCB=cchhr-cchhr
- Specifies a range of DSCB addresses. Within this range is one of the DSCBs that contains the multiply allocated track(s).
- Cde 12
- DSCB contains an extent that is above the 65,520 Cylinder line but is not a multiple of 21 Cylinders. This indicates an extent error.
- Cde 16
- DSCB contains a split-cylinder extent. This type of extent is no longer supported..
- EXTENT=cchh
- Specifies the first track of the extent in error.
- DSCB=cchhr
- Specifies the address of the DSCB in error.
System action
For Cde 0, 8, and 16, if the error occurred during allocation, the system ends the job; if the error occurred in the middle of a job extending the space allocation to a data set, the system abnormally ends the job.
For Cde 12, the system ends the job.
Operator response
Notify the system programmer.
System programmer response
If the error recurs and the program is not in error, look at the messages in the job log for more information. Search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide the SYSOUT output for the job.
Programmer response
Analyze the volume to determine the cause of the error.
For Cde 0, if two data sets were allocated to the same space and the overlapping extent is mapped by SYS1.DFDSS.DEFRAG.xxxxxxxx, rerun the DFDSS DEFRAG job. DFDSS will correct the error. Then rerun the job that was ended with this message. If the overlapping extent is not mapped by SYS1.DFDSS.DEFRAG.xxxxxxxx, scratch one of the data sets allocated to the same space, and run the job again.
For Cde 12 or Cde 16, scratch the data set that is creating the error, and run the job again.
Source
DFSMSdfp
Module
IGG0325P, IGG0325Q, IGG0325R, IGG0325U, IGG0325V, IGG0325W, IGG0325Z
Routing code
4,10
Descriptor code
4