IEC185I text ERROR ON SETPRT TO SYSOUT ddname REASON CODE rsncde
Explanation
text is one of the following:
- QMGRIO
- CLOSE
- OPEN
- SEGMENTING
- ENQ
- MULT DCB
A SETPRT macro instruction was issued for the SYSOUT data
set identified in the ddname field of the message text. One of the
following errors occurred:
- QMGRIO ERROR, reason code X'00000008': an error occurred while SETPRT processing was attempting to read a JFCB or JFCBE control block from the system work area (SWA).
- CLOSE ERROR, reason code X'0000000C': an error occurred when SETPRT processing invoked the CLOSE subsystem interface for the previous data segment.
- OPEN ERROR, reason code X'00000010': an error occurred when SETPRT processing invoked the OPEN subsystem interface for the new data segment being created.
- SEGMENTING ERROR, reason code X'00000014': an error occurred while the scheduler spool file allocation routine was segmenting the data set.
- ENQ ERROR, reason code X'00000018': SETPRT processing issued an ENQ macro instruction that failed.
- MULT DCB ERROR, reason code X'0000001C': More than one DCB was opened for the SYSOUT data set.
In the message text:
- ddname
- The DD name.
- rsncde
- The reason code.
System action
SETPRT processing ends and places a return code in register 15 and a reason code in register 0.
Operator response
Notify the system programmer.
System programmer response
If the error recurs and the program is not in error, look at the messages in the job log for more information. Search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide the JCL and the SYSOUT output for the job.
Programmer response
Follow your installation's procedures for correcting the error. If necessary, contact your programming support personnel.
Source
DFSMSdfp
Module
IGG08117
Routing code
11
Descriptor code
-