IEC161I (return code 201) rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat
Explanation
For general information about message IEC161I, see the explanation for return code 001.
Specific information for this return code: Open detected an Interrupt Recognition condition while opening a data set for input processing.
System action
Open processing continues. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 76 (X'4C').
Programmer response
You may continue processing the data set, however, a critical operation was interrupted on this data set and the operation did not complete. Erroneous results could occur. You may wish to run the access method services DIAGNOSE command against the Catalog and VVDS entries associated with this data set to identify possible problems.
Module
IDA0192B, IDAV192B
Routing code
11
Descriptor code
6