IEC037I 008-rc,mod,jjj,ddname, dev,ser,dsname
Explanation
The error occurred following processing of a CHECK macro instruction during the processing of the creation of a direct data set.
- rc
- Associates this message with system completion code 008 and with the return code.
- jjj
- The job name.
- sss
- The step name.
- ddname
- DDname
- dev
- The device number.
- ser
- The volume serial number.
- mod
- The name of the module in which the error occurred.
- dsname
- The data set name.
- Return Code
- Explanation
- 04
- During the creation of a direct data set, EOV was unable to allocate more space because the current volume was taken. The user returned to the CHECK module from his SYNAD routine.
- 08
- During the creation of a direct data set, an I/O error occurred and the SYNAD exit was taken. The user returned from his SYNAD routine to the check module.
System action
The user's DCB ABEND exit routine will receive control if one was specified. On return, the following control blocks are traced to a GTF data set for return code 04:
1) all DEB extents and 2) the first 88 bytes (or less if block size is less) of the user's output record. No control blocks are traced for return code 08. In both cases, the task is ended.
System programmer response
For return code 04, if the error recurs and the program is not in error, search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide the JCL and the SYSOUT output for the job.
For a return code of 08, if the error recurs and the program is not in error, search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM Support Center. Provide the JCL, the SYSOUT output for the job, and all printed output and output data sets related to the problem.
Programmer response
For return code 04, allocate more space or more volumes. For return code 08, check the IOB in error. If the IOBCSW field does not indicate a user error, (user's data area less than block size or not in user key, which could result in a channel program check), rerun the job.
Source
DFSMSdfp
Module
IGG019BS
Routing code
11
Descriptor code
6