Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Specifying RJE workstation characteristics z/OS JES2 Commands SA32-0990-00 |
|
Use the $T RMT(nnnn) command to change the characteristics of RJE workstations. The AUTOLOG= parameter specifies whether an SNA terminal is to be automatically connected when output or messages are queued for transmission to the terminal. The DISCINTV=nnnn parameter specifies the time interval (in seconds) after which, if there has been no session activity, the RJE workstation is disconnected from the processing unit. The MFORM= parameter controls the amount of information displayed for JES2 BSC remote operator messages for a specified console. For messages that cannot be displayed on a console, use the MSGPRT=Y|N parameter to specify whether JES2 should print those messages (MSGPRT=Y) or discard them (MSGPRT=N). Note that certain parameters on the $T RMT(nnnn) command can only be altered when the RJE workstation is inactive. |
Copyright IBM Corporation 1990, 2014
|