Use the agent_id_list statement to specify
which agents are allowed to connect to the Advisor. This statement
is optional.
Rules: - If you are using AT-TLS with SERVAUTH access control checks to
validate all Agent connections to this Advisor, this statement is
optional. If you specify this statement, but AT-TLS is used for the
connection, this statement is ignored. If you omit this statement,
AT-TLS is required and the security checks must succeed.
- If you are not using AT-TLS with SERVAUTH access control checks
to validate all Agent connections to this Advisor, this statement
is required.
Syntax
.-------------------------------.
V |
>>-agent_id_list--{------agent_ipaddr ..agent_port---+--}------><
Parameters
- agent_ipaddr..agent_port
- Use agent_ipaddr..agent_port to specify
a list of Agents that are allowed to connect to the Advisor. This
parameter is required. The list consists of one or more blank-delimited
IP address and port pairs each specified on a separate line, which
are all contained within braces. There should be no spaces between
the IP address, the two ellipses (..), and the port. These pairs
represent the IP address and port of a given Agent.
There is
no limit to the length of a line. The IP address can be an IPv4 or
an IPv6 address. The IPv4 INADDR_ANY address (0.0.0.0) and the IPv6
unspecified address (::) are not allowed. If agent_ipaddr..agent_port is
specified, this parameter must match the addresses specified in the
host_connection configuration statement on the Agents.
The
valid range of port values is 1 - 65 535.
Rule: You can specify only complete IP addresses. You cannot
specify host names, prefixes, or subnets. Any given agent_ipaddr..agent_port pair
must be specified on one line; it cannot be continued to a subsequent
line.