specifies the zone (called the comparison
zone) that SMP/E should compare against the input zone for SYSMOD
content. You can specify a single target zone or distribution zone
name. In addition, a global zone CSI data set and
zone name can be specified if the comparison zone is defined in a
different global zone. The COMPAREDTO zone must not be
the same as the zone specified on the INZONE operand. A report
is issued to indicate which SYSMODs were in the input zone but not
in the comparison zone.
COMPAREDTO is a required operand on the
REPORT SYSMODS command.
Note: COMPAREDTO is allowed only
on the REPORT SYSMODS command.
INZONE
specifies the input zone that SMP/E should use to compare against
another zone (called the comparison zone)
for SYSMOD content. You can specify a single target zone or distribution
zone name. This must not be the same as the
zone specified on the COMPAREDTO zone. A report is issued to indicate
which SYSMODs were in the input zone but not in the comparison zone.
INZONE
is a required operand on the REPORT SYSMODS command.
Note: INZONE
is allowed only on the REPORT SYSMODS command.
NOPUNCH
indicates that SMP/E should not write any output to SMPPUNCH.
If NOPUNCH is not specified, JCL or
commands are written to SMPPUNCH. This output contains JCL or commands
that can be used for further processing.
Note: The output
produced by REPORT SYSMODS processing contains commands for installing
SYSMODs from the input zone that are applicable to the comparison
zone.
SYSMODS
requests a report comparing the SYSMOD content of two zones.
SYSMODS
is a required operand for the REPORT SYSMODS command.
Note: SYSMODS
is mutually exclusive with CALLLIBS, CROSSZONE, SOURCEID, and ERRSYSMODS.