CNZH messages
- CNZHF0002I
No active console found with MASTER authority that has command association to system system_name . - CNZHF0003I
One or more consoles are configured with a combination of message scope and routing code values that are not reasonable. - CNZHF0004I
Retaining eventual action messages may consume storage needed by critical or immediate action messages. - CNZHF0005I
One or more consoles are configured to receive messages intended only for programmers. - CNZHF0006E
One or more EMCS consoles are defined with a multi-system message scope and are receiving the hardcopy message set. - CNZHF0007E
System console name is configured to receive messages from a remote system. - CNZHF0008I
System console name is not configured to receive the minimum set of routing codes (1, 2, and 10). - CNZHF0009E
The number of inactive EMCS consoles (number) is greater than the source specification of value. - CNZHF0010E
System console name is running in Problem Determination mode. - CNZHF0012E
An obsolete version of Message Flood Automation is active - CNZHF0014E
Console Services is operating in Shared Mode instead of the preferred Distributed Mode. - CNZHF0015E
The current setting of ALLOWCMD for the system console (acmd) does not match the parameter value (value). - CNZHF1001E
The PARM value specified is longer than the maximum length of parmlen. - CNZHF1002E
A PARM value of "parmvalue" was specified which was not numeric. - CNZHF1003E
A PARM value of "parmvalue" was specified. The PARM value must be a valid integer between minvalue and maxvalue. - CNZHF1004I
The system console is not present. The check is not applicable in this environment. - CNZHF1005I
The system is in XCF local or monoplex mode. The check is not applicable in this environment. - CNZHF1006I
No parameters are expected for this check. Use the MODIFY hzsproc UPDATE command to reset the parms. - CNZHF1007E
A PARM value of "parmvalue" was specified. The PARM value is not an acceptable value. - CNZHR0012I
The following components of an obsolete Message Flood Automation installation were detected: Message Exit (IEAVMXIT)Command Exit (CNZZCMXT) - CNZHS0002I
At least one active console has MASTER authority and command association to system &hzssysname;. - CNZHS0003I
All consoles are configured with a reasonable combination of message scope and routing code values. - CNZHS0004I
The Action Message Retention Facility (AMRF) is not active or eventual action messages are not being retained. - CNZHS0005I
There are no consoles configured to receive messages intended only for programmers. - CNZHS0006I
There are no EMCS consoles with a multi-system message scope that are receiving the hardcopy message set. - CNZHS0007I
System console name is configured to receive messages from only the local system. - CNZHS0008I
System console name is configured to receive at least the minimum set of routing codes (1, 2, and 10). - CNZHS0009I
The number of inactive EMCS consoles (number) is within the source specification of value. - CNZHS0010I
System console name is not running in Problem Determination mode. - CNZHS0012I
No obsolete versions of Message Flood Automation are active. - CNZHS0015I
The ALLOWCMD setting for system console name matches the parameter setting;