Starting the Subsystem Interface Task

The Subsystem Interface Task is started with a standard MVS Start command:

Issue: S CNMSJ010,JOBNAME=SYSVSSI,SUB=MSTR
Note: If you specified a different JCL procedure name (sa_nvssi_start_proc) or job name (sa_nvssi_start_job) for the subsystem interface task, then use the values as specified in the INGDOPT Configuration Options file.
After the task is initialized, the following message appears:

CNM541I NetView subsystem SYSV is fully functional

If this message is not displayed, see which of these actions can help you:

  • Find the messages that are displayed on the MVS console to identify the cause.
  • Verify that you have the proper authority.
  • Be sure that you performed correctly all steps of the configuration that are described above in this chapter.