EEZA0105I The adapter has been stopped due to a failure, rc=return code
Explanation
The automation adapter stopped
because an error occurred. All possible stop delay periods are over.
The process stops immediately. The return code might be:
- 12
- if initial contact failed
- 13
- if the remote contact activity threshold is exceeded
- 16
- if a plug-in forced termination of the automation adapter
- 20
- if initialization failed
- 24
- if an error occurred after initialization was successful
- 28
- if an unsupported environment is detected
System action
The automation adapter stops.
Operator response
Search for error messages that were issued previously. On z/OS return code 28 might be caused by the 64-bit JVM. You should use the 32-bit JVM instead.