Hardware Interfaces: Additional Recovery Information

BCP Internal Interface Recovery Information
How to Switch the IP Address for Target Hardware Used by Processor Operations
This description is only valid for target hardware (defined as 'Processors' in the SA z/OS customization dialog) with a connection type of SNMP.
How to Terminate BCP Internal Interface Connections or Clear Hardware Control Blocks after a Connection Failure
There are occasions when it may be necessary to terminate BCP internal interface connections, for example, prior to issuing a CLOSE IMMED to terminate Z NetView and Z System Automation.
Recovery of Processor Operations Target System Connections in the event of Hardware Management Console Outage
Processor Operations target system connections rely on a fully operational Support Element (SE) or a Hardware Management Console (HMC), in order to monitor active target system connections or to execute commands against defined target systems.
Using the ProcOps HOLD Session Mode