ASSIGN

Purpose

You can route messages to groups of operators. Routing groups that are used in message automation must be defined before automation is enabled. The ASSIGN statement identifies the operator groups.

Syntax

The ASSIGN statement has the following syntax:

ASSIGN

Read syntax diagramSkip visual syntax diagramASSIGN.groupname. GROUP= ,operatorid
where:
groupname
Is the 1 - 7 character group name.
operatorid
Is the list of operator IDs separated by commas.

Usage notes

  • You can assign up to a maximum of 255 operator IDs to each message receiver group.
  • You can also use the ASSIGN command to assign operator IDs to groups. For more information, refer to the IBM Z® NetView Command Reference Volume 1 (A-N) or the NetView® online help.