hostcmdoper
 
>>-tserver hostcmdoper--+-------------------------+------------->
                        '- -u NetView_operator_ID-'
 
>--+----------------------+--+--------------------+--+-----+---->
   '- -p NetView_password-'  '- -k encryption_key-'  '- -a-'
 
>--+-----+--+-----+--------------------------------------------><
   '- -s-'  '- -d-'
 

Issue this command before issuing the hostcmd command to set the NetView® operator ID and password or password phrase. The hostcmdoper command can also be used to display or delete the NetView operator ID and password or password phrase in the ihsshiccc.cfg file.

-u

Specifies the NetView operator ID where you want to issue a hostcmd command.

-p

Specifies the NetView password or password phrase where you want to issue the hostcmd command.

-k

Specifies the new key for encrypting the NetView password or password phrase. This encryption key must be 32 characters or 64 hexadecimal characters in length.

Note:

This operand cannot be specified with any other operand.

-a

Specifies to migrate the password file to the new encryption level.

Note:

This operand cannot be specified with any other operand.

-s

Displays the NetView operator ID that is stored in the ihsshiccc.cfg file. This operand cannot be specified with any other operand.

-d

Deletes the ihsshiccc.cfg file, which stores the NetView operator ID and password or password phrase. This operand cannot be specified with any other operand.

If the hostcmdoper command is never issued or if the -d option is run, and then the hostcmd command is run, the hostcmd command either uses the operator ID and password or password phrase that is stored in the ihsshstc.cfg file or prompts the user for the operator ID and password or password phrase. The password or password phrase is not encrypted in the ihsshstc.cfg file.