Deploy (D) flag not set after ResetPlan command used

The deploy (D) flag is not set on workstations after the ResetPlan command is used.

Cause and solution:

This is not a problem that affects the processing of events but just the visualization of the flag which indicates that the event configuration file has been received at the workstation.

No action is required, because the situation will be normalized the next time that the event processor sends an event configuration file to the workstation.

However, if you want to take a positive action to resolve the problem, perform the following steps:
  1. Create a dummy event rule that applies only to the affected workstations.
  2. Perform a planman deploy to send the configuration file.
  3. Monitor the receipt of the file on the agent.
  4. When it is received, delete the dummy rule at the event processor.