Getting CCMS alert status

To get the current status of a CCMS alert from IBM Workload Scheduler, use the external task Get Information (GI). To replace the command arguments with the actual values, refer to the output returned by the event rule you defined. For details about the correspondence between the CCMS properties and the Console and composer properties, see Table 1.

From a command line, enter the following command:
Figure 1. Command syntax

1   -r3batch   -t GI   -c Agent_name   -- " -t GAS   -alsysid sap_system_ID   -msegname alert_mte_segment   -aluniqnum alert_UID   -alindex alert_index   -alertdate alert_date   -alerttime alert_time  "
Where:
-t GI
Identifier of the task to be performed, in this case GI (Get Information).
-c Agent_name
The name of the dynamic agent workstation, or the unique identifier for the extended agent workstation connected to the SAP system where the MTE for which the alert was raised is located. For information about retrieving the unique identifier for the extended agent workstation, see UNIQUE_ID.
-t GAS
Identifier of the task to be performed, in this case GAS (Get Alert Status).
-alsysid sap_system_ID
Identifier of the SAP system where the MTE for which the alert was raised is located. If the name contains blanks, enclose it between single quotes.
-msegname alert_monitoring_segment
Name of the alert monitoring segment. You can specify from 1 to 40 characters.
-aluniqnum alert_UID
Unique identifier of the alert, made up of 10 characters.
-alindex alert_index
Alert index, made up of 10 characters.
-alertdate alert_date
Date of the alert, in the format yyyymmdd.
-alerttime alert_time
Time of the alert, in the format hhmmss.
The following is an example of how to retrieve the current status of a CCMS alert:
r3batch -t GI -c horse10 -- " -t GAS -alsysid T10 
        -msegname SAP_CCMS_horse10_T10_00 -aluniqnum 0017780869 
        -alindex 0000000104 -alertdate 20081007 -alerttime 040356" 

You are returned the current status of the alert.