The setup wizard guides you through installing Tivoli® Storage FlashCopy® Manager on
your computer.
Before you begin
Before you begin, verify that your environment meets the
hardware and software prerequisites. For the most current requirements,
review the Hardware and Software Requirements technote that is associated
with the level of your Tivoli Storage FlashCopy Manager. This
technote is available in the Tivoli Storage FlashCopy Manager - All Requirement
Documents website at http://www.ibm.com/support/docview.wss?uid=swg21427692. When you are at the website, follow the
link to the requirements technote for your specific release or update
level.
Procedure
Complete the following steps to install Tivoli Storage FlashCopy Manager:
- Log on with administrator credentials and complete the
following steps:
- Insert the Tivoli Storage FlashCopy Manager product
DVD into the DVD drive. If autorun is enabled, the
installation dialog starts automatically. Otherwise, select ,
and specify: x:\setupfcm.exe where x is
your DVD drive. Click OK.
- Follow the installation instructions.
- Click Finish to complete the
installation of Tivoli Storage FlashCopy Manager.
- Configure Tivoli Storage FlashCopy Manager by
using the configuration wizard.
- Start the Management Console. Click . When you start the Management Console,
a welcome page is displayed. If Tivoli Storage FlashCopy Manager is
not configured, the configuration wizard starts.
- If the configuration wizard does not start automatically,
go to in the tree view, and
select one of the following wizards:
- Standalone configuration wizard
- Tivoli Storage
Manager configuration
wizard
- Mailbox restore only configuration wizard
Click Start in the Actions pane.
- In the configuration wizard, select the applications
to protect, verify requirements, provision, and configure.
- After you complete the configuration wizard, verify that
everything is properly configured by selecting each workload instance
in the tree view and completing the following steps:
- Click the Automate tab.
- Click Open in the toolbar.
- Type verify. The following three
file names are listed.
verify_sql.txt
verify_exc.txt
verify_fs.txt
The verify_fs.txt file is used with
the Management Console (MMC) graphical user interface and is part
of the base product installation.
- Select and open the file that matches the workload.
- Click Run in the toolbar.
When the commands run with no warnings or errors, the
configuration is verified.
The
verify_sql.txt file
contains the following commands:
query tdp
query tsm
query sql
The
verify_exc.txt file
contains the following commands:
query tdp
query tsm
query exchange
The
verify_fs.txt file
contains the following commands:
query component
query config
- Back up and restore a set of test data. Refine your configuration
settings as necessary.
- Define the policy settings and scheduled operations.