You can set the TSA system time, date, and local time zone during setup.
Procedure
Figure 1. Clock
Select your local time zone from the GMT offset
drop-down list.
Select the daylight saving time (DST) adjustment from the DST
adjustment drop-down list.
Note: Not all time zones allow DST. If this option is selected for a time zone that does not allow
DST, an error message is displayed.
Select a method for updating the system clock from the Select Time
Option drop-down list.
Options include synchronizing the system clock with a
Network Time Protocol (NTP) server to update the system clock automatically or manually configuring
the system clock.
If you selected to manually configure the system clock, you must set the system date
and time. Enter the date and time information into the Date and
Time fields.
If you selected to synchronize the system clock with a Network Time Protocol (NTP) server to
update the system clock automatically, you must then specify the IP addresses or host names for the
NTP servers. Type the IP address or host name information for up to two servers in the
NTP server fields.
Note: Make sure that the NTP server is accessible through the network to TSA.
What to do next
Click Save & Continue to save clock information and continue to the
Transmission Schedule page.
-or-
Click Skip to skip to the Transmission Schedule
page.
To modify settings on the previous step of the wizard
Click Back to go back to the Registration page.
To exit the wizard
Click Exit Wizard to exit the Setup Wizard and go to
the Summary page.
