Cable routing

Edit online

Normally, cables are routed through the rear openings at the bottom of the frame. If the library is being installed on a solid (non-raised) floor, your IBM Service Representative can route the Fibre Channel, Ethernet, and power cables through openings in the frame at the top of the library.

Fibre Channel cables and Ethernet cables are routed through the frame opening shown in 1 in Figure 1. Power cables are routed through the frame opening shown in Figure 2. This illustration also shows the cable restraint assembly used to hold the power cables in place.

Figure 1. Access panel for Fibre Channel and Ethernet cable routing

Figure 2. Opening in top of frame for power cables