For LTO 5, TS1140, and later drives, the ethernet port settings
can be configured with the Configure TCP/IP Port command. The Configure
TCP/IP Port command displays the current settings:Figure 1. TCP/IP Port command
You can change any of the settings by stepping through each parameter
- press Enter. To change a parameter, enter
the new value, then press Enter. All data is
sent to the drive and the following screen display is shown:Figure 2. TCP/IP
Port command results
Note: Because earlier drive generations do not have an ethernet port,
the Configure TCP/IP Port command is rejected for
these devices with the following message:
TCP/IP configuration is not supported on this product.
