ZUDFC STOP-stop data collection

Requirements and restrictions

The system must be in NORM state when you enter a data collection command.

MODE-: specifies which mode to use when stopping data collection. Omit the MODE parameter to stop data collection for only the current processor.
ALL: stops data collection on all processors in a loosely coupled complex that are running data collection.
FORCE: specifies data collection to stop on all processors even if the current processor is not running data collection. If you use this parameter, the results of the statistics cannot be predicted.

If you run the ZUDFC STOP command without parameters, TPFDF data collection stops only on the current processor.
The MODE parameter has no affect on the ALCS environment.
You must stop data collection with MODE-ALL to obtain cumulative totals for all processors. If you stop all processors individually, all cumulative totals are lost.
You can use the ZUDFC STOP command to stop data collection before the end of the measurement period specified by the ZUDFC START command.

The following example shows data collection being stopped.

User: ZUDFC STOP
System: UDFC0002I 14.23.54 DATA COLLECTION STOPPED ON PROCESSOR B

For more information about the ZUDFC STATUS command, see ZUDFC STATUS-Display current status of data collections.

For more information about the ZUDFC DISPLAY command, see ZUDFC DISPLAY-Display Data Collection.
For more information about the ZUDFC START command, see ZUDFC START-Start Data Collection.
For more information about the ZUDFC STATUS command, see ZUDFC STATUS-Display current status of data collections.