Function code 9: Display error code log

Edit online

About this task

Function code 9 displays the last 10 error codes, one at a time (the codes are ordered; the most recent is presented first and the oldest is presented last). If there are no errors in the log, function code 0 displays in the Single-character Display (SCD) and exits Maintenance mode.

Procedure

  1. Place the drive in Maintenance mode. For instructions, see Entering Maintenance mode.
  2. Press Unload once per second until 9 appears in the SCD. (If you cycle past the wanted code, press Unload once per second until the code reappears.)
  3. Press and hold Unload, then release it to view the most recent error code.
  4. Press and release Unload again to view successive error codes. Allow 2 - 3 seconds pass between each depression. The Ready light and Fault light flash On/Off once for each successive error code. The SCD displays 0 when all the error codes are displayed.
  5. After all error codes are viewed, exit this function by pressing Unload again. The SCD displays 0 and exits Maintenance mode.