Refreshing and loading files

About this task

The data sets listed constitute one input set. An input set can contain multiple CKFREEZE data sets, multiple SMF files, and multiple HTTP log files. However, an input set can contain only one RACF® unload, or one or more RACF data sets from one split database.

To refresh and load files, complete the following steps:

Procedure

  1. In the Input file panel (Figure 3), type REFRESH in the command line. Press Enter to open the Job submission panel.
  2. In the Job submission panel, type a valid job card in the Job statement information section.
  3. Use the Edit JCL Option (2) to open the normal ISPF editor to customize the JOB statement and make any other necessary changes to the job.
    For example, you might need a JOBLIB or STEPLIB statement to access zSecure Admin and zSecure Audit for RACF. If you copied zSecure Collect for z/OS (CKFCOLL) to an authorized library in the LNKLST, you do not need a JOBLIB or STEPLIB statement for it. Assign a job class with a large or unlimited region size.
  4. Submit the job.

What to do next

Wait until the job runs. If there is a long queue of jobs that are waiting to run, you can exit from zSecure Admin and Audit while the job completes. The job itself takes only a few minutes to run, unless you have a large configuration. You can add a NOTIFY= yourid in the job card. If the job fails, the problem is usually that there is not enough storage. A region size of 64 MB is typically sufficient to run zSecure Collect for z/OS.

After the job is completed, continue with the next procedure.