Changes available at the next LP activation

Edit online

The following changes are available at the next LP activation:

  • Use the IOCP RESOURCE statement to specify the MIF image ID numbers assigned to the LPs. The only way to change the specified MIF image ID numbers is by creating a new IOCDS.
  • Use the Partitions page in the reset profile to change the:
    • LP automatic activation order
  • Use the General page in the image profile to change the:
    • Logical partition identifier
    • Mode of the LP
    • Enablement of the Logical partition time offset
  • Use the Processor page in the image profile to change the:
    • Number of CPs, ICFs, IFLs, or zIIPs
    • Whether or not CPs are dedicated to an LP
    • Weight capping
    • Workload Manager enablement
    • Initial processing weight
    • Initial capping enablement
    • Minimum processing weight
    • Maximum processing weight
    • Absolute capping
  • Use the Options page in the image profile to change the:
    • Minimum input/output (I/O) priority
    • Maximum input/output (I/O) priority
    • Defined capacity
    • CP Management Cluster
  • Use the Security page in the image profile to change the:
    • Global performance data control
    • Input/output configuration control
    • Cross partition authority
    • Logical partition isolation
    • Enable the partition to send commands
    • Enable the partition to receive commands from other partitions
    • Basic counter set authorization control
    • Problem state counter set authorization control
    • Crypto activity counter set authorization control
    • Extended counter set authorization control
    • Basic sampling authorization control
    • Diagnostic sampling authorization control
    • Permit AES key functions
    • Permit DEA key functions
    • Permit ECC key functions
    • Permit HMAC key functions
  • Use the Storage page in the image profile to change the:
    • Central storage definitions
    • Virtual flash memory definitions
  • Use the SSC page in the image profile to change the:
    • Boot selection
    • Host name
    • Administrator user ID
    • Administrator password
    • Network adapters
    • DNS servers
  • Use the Time Offset page in the image profile to change the:
    • Logical partition time offset
  • Use the Load page in the image or load profile to change the:
    • Automatic load data
  • Use the Crypto page in the image profile to change the:
    • Assigned domains
    • Assigned cryptos