Using the AddOnly mode

The most common and simple pattern for using a Connector in AddOnly mode is:

1. Using the Config Editor, add a Connector in AddOnly mode to your workspace. See Creating a Connector.
2. Set the mode (AddOnly) and other connection parameters for this Connector in the Connection tab; required parameters are marked with an asterisk (*). Some Connectors require you to configure a Parser as well in the Parser tab.
3. Set up the Attribute Map; see [Output Attribute mapping](outputattributemapping.html#outputattributemapping "Output Attribute mapping is the process that accomplishes the moving of data from the Work entry in the AssemblyLine to the output destination in the connected system. Output Attribute maps are shown in the Attribute Maps window of the Connector, when brought up in the Connector Editor, with an arrow pointing from the Connector to an entity referred to as "[Target]". They are also shown in the Schema window, under Output Attribute map.").

If you did not create the Connector directly inside an AssemblyLine, then to use the Connector in an AssemblyLine, drag it from its location in <workspace>/Resources/Connectors to the Flow section of the AssemblyLine.

Work entry attributes you have mapped are output to the connected system when the Connector is called by the AssemblyLine.