server task server sync
The server task server sync command synchronizes configuration data between two WebSEAL servers by using the Verify Identity Access server task framework.
Requires authentication (administrator ID and password) to use this command.
Note: The two WebSEAL servers
must be of the same type. The WebSEAL server type is either a:
- WebSEAL running on an appliance.
- WebSEAL running on a standard operating system.
Syntax
server task webseal_server server sync server_name
Options
- webseal_server
- Specifies the fully qualified server name of the installed WebSEAL instance. The webseal_server is the target.
- server_name
- Specifies the name of the WebSEAL server from which data is extracted. Configuration data on the host system is backed up and then synchronized with this data. The server_name is the source.
Authorization
Users
and groups that require access to this command must be given the s (administration)
permission in the ACL that governs the /WebSEAL/host_name-instance_name object.
The sec_master administrative user has permission
by default.
Return codes
- 0
- The command that completed successfully. For WebSEAL server
task commands, the return code is
0when the command is sent to the WebSEAL server without errors.Note: Even if the command is successfully sent, the WebSEAL server might not be able to successfully complete the command and can return an error message. - 1
- The command failed. When a command fails, the pdadmin command provides a
description of the error and an error status code in hexadecimal format (for example,
0x14c012f2). See "Error messages" in the IBM Knowledge Center which provides a list of the Verify Identity Access error messages by decimal or hexadecimal codes.
Examples
The following example synchronizes
configuration data with server
master-webseald-abc.ibm.com: pdadmin> server task default-webseald-abc.ibm.com server sync
master-webseald-abc.ibm.com