Restoring or retrieving data during a failover

Edit online

When the client is redirected to a failover server, you can restore or retrieve replicated data from the server.

Before you begin

Before you begin to restore or retrieve data during a failover:

Ensure that the client is configured for automated client failover.
Ensure that you are connected to an IBM Storage Protect server that replicates client nodes. For more information about failover requirements, see Requirements for automated client failover.

Restriction: In failover mode, you cannot back up or archive data to the failover server.

Procedure

To restore or retrieve data during a failover, complete the following steps:

Verify the replication status of the client data on the failover server. The replication status indicates whether the most recent backup was replicated to the failover server.
Restore or retrieve your data as you would normally do from the client GUI or from the command-line interface.
Tip: Restartable restore operations function as expected when the client is connected to a failover server. However, restore operations that are interrupted when the primary server goes down cannot be restarted after the client fails over. You must run the whole restore operation again after the client is redirected to the failover server.

Results

If the replicated data on the failover server is not current, you are prompted to continue or to stop the restore or retrieve operation.

For example, to restore the build.sh directory at the command-line interface, you issue the following command: Linux operating systems

dsmc res /build.sh

dsmc res C:\build.sh

The following output is displayed:

IBM Spectrum Protect
Command Line Backup-Archive Client Interface
  Client Version 8, Release 1, Level 0.0
  Client date/time: 11/16/2016 12:05:35
(c) Copyright by IBM Corporation and other(s) 1990, 2016. All Rights Reserved.

Node Name: MY_NODE_NAME
ANS2106I Connection to primary IBM Spectrum Protect server 192.0.2.1 failed

ANS2107I Attempting to connect to failover server TARGET at 
192.0.2.9 : 1501

Node Name: MY_NODE_NAME
Session established with server TARGET: Windows
  Server Version 8, Release 1, Level 0.0
  Server date/time: 11/16/2016 12:05:35  Last access: 11/15/2016 14:13:32

  Session established in failover mode to failover server
ANS2108I Connected to failover server TARGET.
Restore function invoked.

ANS2120W The last store operation date reported by the server TARGET of 
05/16/2013 22:38:23 does not match the last store operation date of 
05/21/2013 21:32:20 stored by the client. 
Continue (Yes (Y)/No (N))

If you respond with N, the following message is displayed:

ANS1074W The operation was stopped by the user.

If you respond with Y, restore processing continues as normal, but the data that you restore might not be the most current.