Installing the IBM SAN rack
This section contains the procedures to install a IBM SAN rack (hereafter referred to as the rack) and prepare it for use.
The installation steps are as follows:
- Step 1. Position the rack
- Step 2. Level the rack
- Step 3. Attach the stabilizers
- Step 4. Attach the rack to a concrete floor
- Step 5. Attach the rack to a concrete floor beneath a raised floor
- Step 6. Attach the mounting plates
- Step 7. Attach the front door
- Step 8. Check the customer's ac power source
- Step 9. Check the intelligent power distribution units
- Step 10. Connect switch and device cables
- Step 11. Power on the rack
Attention: Refer to Safety and environmental notices for
safety information and notices before starting any installation or
service procedures.