HWN021673E The probe job on SMI-S provider SMI-S provider IP and Port in format IP:Port did not complete within the time limit of Microseconds microseconds. The job is Percent complete percent complete. Check the SMI-S provider log for job status. Job information: JobCOP . Run the probe job again after the current job has completed.

Explanation

The probe job was started on the SMI-S provider, but did not complete in the specified time limit. The time limit can be set by using the setdscfg CLI command to modify the CIMJobContext.JobRetrievalRetry and CIMJobContext.JobRetrievalSleep parameters in the Db2 table.

  • CIMJobContext.JobRetrievalRetry defines the maximum number of retries to check a job for completion.
  • CIMJobContext.JobRetrievalSleep defines the wait time in microseconds between two retries.

Action

Check the SMI-S provider logs for status of the probe job. Use the setdscfg CLI command to change the CIM job retrieval parameters if necessary. Run the probe again to get the most recent data from the subsystem.

For more information about CLI commands, see the Command-line interface section of the Knowledge Center.