Interoperability Test Service
To test a map on a DataPower Gateway, you must configure the connectivity settings for the Interoperability Test Service in the Map Designer.
The host name or IP address, and a port number for the DataPower Gateway are required. The connection is established using HTTP or HTTPS.
Under Connectivity, to enter values in the fields and the required options for the Interoperability Test Service, click the Interoperability Test Service tab.
- Connectivity
- Definition
- Host
- The host information for the DataPower Gateway. (For IPv6, enclose the IP address in brackets.)
- Port
- The port information of the Interoperability Test Service on the DataPower Gateway.
- Secure Transport
- Establish a secure connection using HTTPS to the Interoperability Test Service.
- Save Messages
- Definition
- Request
- Save a copy of the request message (map_name_Request.msg) in the map directory.
- Response
- Save a copy of the response message (map_name_Response.msg) in the map directory.
- Session
- Generate the DataPower session log ( map_name.dpl) file in the map directory.
- DataPower Gateway Configuration
- Definition
- ITX Audit Log
- The audit context name that the DataPower Gateway references to generate and save the map audit log.
- Support ITX Warnings
- Indicate whether or not to support map warnings on the DataPower Gateway.
- Working Directory
- Definition
- URL
- The working directory Uniform Resource Locator (URL) to resolve the relative RUN map paths.
- Custom
- Use to customize the working directory URL.