Running the map examples

After successfully installing the software, you can run the map examples included in the installation to test the installation to ensure the Command Server is functioning properly.

To run the map example

  1. Run the setup script.
  2. Execute the map:
    • Go to install_dir/examples/general/map/sinkmap
    • From the command line, type:
      
      dtx sinkmap
      

      The Command Server updates the screen while the map executes. If the map ran successfully, the following message is displayed:

      
      Map completed successfully
      

      If the map does not complete successfully, see Using a Command Server for troubleshooting information.