Sending audit data to output and failure terminals through the local environment tree
You can configure a IBM® Transformation Extender map to send audit-log data across IBM Transformation Extender message flow wires by using the IBM Integration Bus local environment (LocalEnvironment) tree. When the IBM Integration Bus message flow runs successfully, the message flow sends the audit-log data to the output terminal of the IBM Integration Bus node. When the IBM Integration Bus message flow fails, the audit log data is sent to the failure terminal of the IBM Integration Bus node (if a failure terminal is wired to the map node).
To enable this feature, set the Audit Location to Memory in the IBM Transformation Extender map settings. Click . The Sized setting can be either ON or OFF.
Map audit information is propagated to the LocalEnvironment.WTX.Audit.MapInst_x location in the IBM Integration Bus local environment tree, where x is the instance of the map run from the IBM Integration Bus. Map instances start at 1, are unique, and are sequential.
The type of audit data information that is propagated to the local environment tree depends on the IBM Transformation Extender Map settings. For example, to send the map execution summary, set MapAudit Switch setting to ON, and set the SummaryAudit Execution setting to Always.