Customizing the access card selection limit in the Request Access wizard
The second step in the Request Access wizard is used to select the accesses that are being requested for a user. There is a limit to the number of accesses that can be requested at one time. You can change this limit to meet your needs.
Before you begin
You must have read or write access to the customizable files and the directories where they are
maintained. See Location of IVIG Service Center customizable files and 
Customizing IVIG Service Center files (Software stack ) for specific details about
where these files are located. Contact your system administrator if you do not have the necessary
permissions.
About this task
The Select accesses page of the Request
Access wizard is used to select the accesses that are being
requested for a user. By default, the number of accesses that can
be selected on the Select accesses page is limited
to 25. But you can change this limit to meet your
needs by modifying the config/UIconfig.properties file.
Procedure
- Make a custom copy of the config/UIconfig.properties file.
- In a text editor, open the UIconfig.properties file
and locate the access.selection.maximum.number property.
- From the top level of the Appliance Dashboard, click .
- Select UIconfig.properties and then click Download.
- Change the value to the expected access limit for your
organization. For example,
20. - Click Save Configuration.
Results
config/UIconfig.properties file.What to do next
You can verify the change immediately
in a single-server WebSphere® Application
Server environment. In a managed-cluster environment, you must wait
until after the configuration is synchronized to the application servers
in the cluster. For information about synchronizing the WebSphere
managed-cluster environments, see the WebSphere Application Server section
of the IBM Knowledge Center. Log in to the IVIG Service Center. Start
the Request Access wizard and confirm that the
number of accesses selected is restricted to the specified limit.