Install a Remote Perimeter Server in a Less Secure Network on UNIX or Linux

Edit online

About this task

To install a perimeter server in a less secure network than your Secure Proxy server:

Procedure

  1. Navigate to the directory containing the downloaded perimeter server installer file for your platform.

    Platform

    Installation File Name

    IBM System p5 and IBM Power System

    PS.V3410.AIX.bin

    HP Integrity system with Intel Itanium processor

    PS.V3410.HP-IA.bin

    HP 9000 (PA-RISC)

    PS.V3410.HP.bin

    x64/x86 Linux (32-bit)

    x64/x86 Linux (64-bit)

    PS.V3410.Linux.bin

    PS.V3410.Linux_X64.bin

    Sun SPARC system

    PS.V3410.SolarisSPARC.bin
  2. Copy the perimeter server installation file for your platform to your home directory or base directory. If you are using FTP to copy the file, make sure your session is set to binary mode.
  3. To begin the installation, type the installation file name and press Enter.

    The installation program displays the Introduction screen.

  4. Press Enter to continue the installation.

    If you type quit, the installation program will terminate.

  5. Read the License Agreement information. Press Enter to page through the license agreement. When you are prompted to accept the License Agreement, press Y or y. The Choose Installation Folder screen is displayed.
  6. Press Enter to accept the default installation folder, or type the absolute path name of the directory where the perimeter server will be installed.
  7. Confirm that the installation directory is correct by typing Y or y. The Network Zone screen is displayed.
  8. Type 1 to install the perimeter server in a less secure network. The installation program displays a list of network interfaces available on the perimeter server host.
  9. Select the network interface for the perimeter server to use to communicate with the Secure Proxy engine, or press Enter if a specific interface address is not required.
  10. Type the port number of the local port the perimeter server will listen on for requests from the Secure Proxy engine. Specify a port number greater than or equal to 1024. Press Enter. The installation program displays a list of network interfaces available on the perimeter server host.
  11. Select the network interface for the perimeter server to use to communicate with trading partners, or press Enter if a specific interface address is not required.
  12. Verify the Post-Installation Summary information, and press Enter.

    When the perimeter server is installed, the installation program displays an Installation Complete message.

  13. Press Enter to exit the installation.
  14. Change to the installation directory.
  15. Type startupPS.sh to start the perimeter server.