Unpacking the node

Before you unpack the node, ensure that you review and follow all related instructions.

Before you begin

The node and related parts are shipped in a single box, containing the following:

Node with the following components preinstalled:
- Node canister with adapters, SFPs, and memory feature codes preinstalled
- Two power supplies and two power interposers
- Bezel
Rail kit including left and right rails, securing screws, and locating pins
Two power cables
Optional OM3 fiber cables
Fibre Channel cables

Note: You will need a box knife to unpack the node.

About this task

CAUTION:

Lifting the enclosure requires two persons or a suitable mechanical lift. If there are less than two persons or a lifting equipment is not available, reduce the weight of the enclosure temporarily by removing the two PSUs and the node canister.

Procedure

Cut the box tape and open the lid of the shipping carton.
Remove the rail kit box and set it aside in a safe location.
Lift the front and rear foam packing pieces from the carton.
Remove the four corner reinforcement pieces from the carton.
Using the box knife, carefully cut the four corners of the carton from top to bottom.
Fold the sides and back of the carton down to uncover the rear of the node.
If necessary, carefully cut along the lower fold line of the sides and remove them.
Carefully cut the raised section of the foam packing away from the rear of the enclosure.
Lift the enclosure from the shipping carton.
Carefully cut open the bag covering the rear of the enclosure.
If you do not have two persons or mechanical lift available, then remove the power supply units (PSU) from the enclosure
Record the last six digits of the serial number on the back of the each power supply, and then set the power supply aside.
Remove the node canister from the enclosure only if you do not have two persons or mechanical lift available.
Record the serial number on the canister release handle, and then set the canister aside.