1370 ERP occurred

Explanation

This error was reported because a large number of disk error recovery procedures were run by the disk controller. The problem is probably caused by a failure of some other component on the system.

User response

  1. View the event log entry and determine the disk that was being accessed when the problem was detected.
  2. Complete the disk controller problem determination and repair procedures for the disk that was identified in step 1.
  3. Complete problem determination and repair procedures for any Fibre Channel (FC) switches connected to the system and any other FC network components.
  4. If any problems are found and resolved in steps 2 and 3, mark this error as fixed.
  5. If no switch or disk controller failures were found in steps 2 and 3, collect an event log dump file, and then contact IBM® Support Center.
  6. Run the fix procedure from the event log menu in the GUI.

Possible Cause-FRUs or other:

  • None

Other:

  • Enclosure/controller fault
  • Fibre Channel (FC) switch