overridequorum

Use the overridequorum command to start the manual override command.

Syntax

Read syntax diagramSkip visual syntax diagram satask overridequorum -force

Parameters

-force
(Required) Overrides any quorum decision that is made by the system.
Important: This command must only be used with assistance from IBM Support. Using this command incorrectly can cause data corruption, by creating two separate clusters which both write to the same disks. To avoid this, the command must only be used in a disaster recovery scenario, when it has been ensured that nodes at the other site can never come back online.

Description

This command starts the manual override command. This command is valid on nodes that are in a starting state with either of the following node errors:
  • 551
  • 921

An invocation example

satask overridequorum -force

The resulting possible outputs: 

No feedback.