Increasing the number of file handles on Linux computers

For best product performance, increase the number of file handles above the default of 1024 handles.

Before you begin

Important: Before you work with your Rational® product, increase the number of file handles. Most Rational products use more than the default limit of 1024 file handles per process. A system administrator might need to make this change.

About this task

Ensure that you complete the following steps correctly. If this procedure is not completed correctly, your computer will not start.

Procedure

  1. Log in as root. If you do not have root access, you will need to obtain it before continuing.
  2. Change to the etc directory.
    Attention: If you decide to increase the number of file handles in the next step, do not leave an empty initscript file on your computer. If you do so, your computer will not start the next time that you restart it.
  3. Use the vi editor to edit the initscript file in the etc directory. If this file does not exist, type vi initscript to create it.
  4. On the first line, type ulimit -n 4096. The point is that 4096 is significantly larger than 1024, the default on most Linux computers.
    Important: Do not set the number of handles too high, because doing so can negatively impact system-wide performance.
  5. On the second line, type eval exec "$4".
  6. Save and close the file after making sure you have completed steps 4 and 5.
  7. Optional: Restrict the number of handles available to users or groups by modifying the limits.conf file in the etc/security directory. Both SUSE Linux Enterprise Server (SLES) Version 9 and Red Hat Enterprise Linux Version 4.0 have this file by default. If you do not have this file, consider using a smaller number in step 4 in the previous procedure (for example, 2048). Do this so that most users have a reasonably low limit on the number of open files that are allowed per process. If you use a relatively low number in step 4, it is less important to do this. However, if you set a high number in step 4 earlier and you do not establish limits in the limits.conf file, computer performance can be significantly reduced.
    The following sample limits.conf file restricts all users, and then sets different limits for others afterwards. This sample assumes that you set handles to 8192 in step 4.

    *      soft nofile 1024
    *      hard nofile 2048
    root    soft nofile 4096
    root    hard nofile 8192
    user1   soft nofile 2048
    user1 hard nofile 2048

    Note that the * in the preceding example sets the limits for all users first. These limits are lower than the limits that follow. The root user has a higher number of allowable handles open, while number available to user1 is between the two. Make sure that you read and understand the documentation contained in the limits.conf file before making changes.

Feedback