Syslog log source parameters for Check Point Multi-Domain Management (Provider-1)

If QRadar does not automatically detect the log source, add a Check Point Multi-Domain Management (Provider-1) log source on the QRadar Console by using the syslog protocol.

When using the syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect syslog events from Check Point Multi-Domain Management (Provider-1):

Table 1. Syslog log source parameters for the Check Point Multi-Domain Management (Provider-1) DSM
Parameter	Value
Log Source type	Check Point
Protocol Configuration	Syslog
Log Source Identifier	Type the IP address or host name for your Check Point Multi-Domain Management (Provider-1) appliance.