Syslog log source parameters for Honeycomb Lexicon File Integrity Monitor

If QRadar does not automatically detect the log source, add a Honeycomb Lexicon File Integrity Monitor log source on the QRadar Console by using the syslog protocol.

When using the syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect syslog events from Honeycomb Lexicon File Integrity Monitor:

Table 1. Syslog log source parameters for the Honeycomb Lexicon File Integrity Monitor DSM
Parameter	Value
Log Source Name	Type a name for your log source.
Log Source Description	Type a description for the log source.
Log Source Type	Honeycomb Lexicon File Integrity Monitor
Protocol Configuration	Syslog
Log Source Identifier	Type the IP address or host name for the log source as an identifier for events from your Honeycomb Lexicon FIM installation. The Log Source Identifier must be unique value.
Enabled	Select this check box to enable the log source. By default, the check box is selected.
Credibility	From the list, select the Credibility of the log source. The range is 0 - 10. The credibility indicates the integrity of an event or offense as determined by the credibility rating from the source devices. Credibility increases if multiple sources report the same event. The default is 5.
Target Event Collector	From the list, select the Target Event Collector to use as the target for the log source.
Coalescing Events	Select this check box to enable the log source to coalesce (bundle) events. By default, automatically discovered log sources inherit the value of the Coalescing Events list from the System Settings in QRadar. When you create a log source or edit an existing configuration, you can override the default value by configuring this option for each log source.
Incoming Event Payload	From the list, select the incoming payload encoder for parsing and storing the logs.
Store Event Payload	Select this check box to enable the log source to store event payload information. By default, automatically discovered log sources inherit the value of the Store Event Payload list from the System Settings in QRadar. When you create a log source or edit an existing configuration, you can override the default value by configuring this option for each log source.